Roads and Maritime Services updates notice for road trains

27 July 2012

Roads and Maritime Services (RMS) has replaced the notice allowing road trains with eligible tri-axle converter dollies to operate at full axle group masses.

"From 1 July changes were made to the notice to allow road trains with eligible tri-axle dollies to operate at full axle group mass limits where they are fitted with certified road friendly suspension," RMS Director Customer and Compliance, Peter Wells said.

"Previously, road trains operating in New South Wales with tri-axle converter dollies were not permitted the full sum of axle group mass limits which had the effect of indirectly limiting the mass limits on these vehicles.

"Eligible road train vehicles were required to have a longer minimum distance between axle groups of the leading semi trailer and the converter dolly tri-axle group with the increased mass limits.

"The minimum axle spacing aims to reduce concerns about the effect of increased mass limits on bridges.

"Further consultation with the heavy vehicle industry identified certain types of road train vehicles, for example those with tipping trailers or built to carry livestock, may not be able to meet the requirement under the notice in relation to the minimum distance between adjacent axles.

"A graduated table of axle group spacings and adjacent axle group mass limits is included in the notice and has been developed to help operators to obtain the benefits of increased mass limits for eligible tri-axle dollies without posing any additional risk to bridges,” Mr Wells said.

The notice which takes effect from today is available at /heavyvehicles/downloads/permitnotices/permit_notices_dl1.html

Share this page: