Performance Based Standards

Performance Based Standards (PBS) is a national heavy vehicle scheme designed to offer the heavy vehicle industry the potential to achieve higher productivity and safety through innovative and optimised vehicle design. This webpage describes how PBS vehicles are provided with access to the NSW road network

About PBS

If you are interested in building a heavy vehicle that does not meet the current preseciptive Heavy Vehicle National Law (HVNL) standards, or have an idea for an innovative heavy vehicle that would manage your freight task in NSW more efficiently, then PBS may be the solution you are looking for.

Further information about the PBS Scheme including vehicle standards is available on the National Heavy Vehicle Regulator (NHVR) website.

PBS road network access in NSW

The operation of PBS vehicles in NSW is by access permit and/or National PBS Notice depending on the type of PBS vehicle. These access permits and/or National Notices provide details on the conditions of operation and road network access permitted for a PBS vehicle in NSW.

PBS road network access in NSW is based on the four PBS performance levels (Levels 1 – 4) and access classes ‘A’ and ‘B.’ For PBS Level 2 and above, PBS road network access is divided into ‘A’ and ‘B’ networks based on vehicle length as shown in Table 1.

Table 1: PBS networks

PBS Performance Level Access Class 'A' Access Class 'B'
1 ≤ 20 metres in length ≤ 20 metres in length
2 ≤ 26 metres in length ≤ 30 metres in length
3 ≤ 36.5 metres in length ≤ 42.5 metres in length
4 ≤ 53.5 metres in length ≤ 60.0 metres in length

Eligible PBS Truck and Dog combinations may operate on approved routes contained in Appendix 1 of the NSW Schedule to the National Class 2 PBS Level 1 & 2A Truck and Dog Trailer Authorisation Notice.

PBS approved Level 1 vehicles/combinations and Level 2 access class ‘A’ vehicles/combinations (excluding PBS A-doubles) may operate on approved network routes shown in the PBS map under a NHVR issued access permit if they:

  • Comply with the bridge formulae for the level of access requested (ie Tier 1 compliant)
  • Have a width of not greater than 2.5m and
  • Have a total height not exceeding 4.3m for Level 1 and 4.6m for Level 1.

    Note:
    PBS vehicles that are approved to operate with a height exceeding 4.3m and up to 4.6m must only operate on approved network routes that are approved for both 4.6m high heavy vehicles and the applicable PBS level and access class.

All other PBS approved vehicles must be assessed for suitable network access in NSW and must operate under a NHVR issued access permit.

Operators of PBS vehicles must comply with the PBS road network access conditions.

PBS road network access conditions

Operators of PBS vehicles must abide by the following the network conditions while operating in NSW:

  • It is a road access condition that all PBS Level 2 access class ‘B’ vehicles/combinations and greater be enrolled and monitored in the Intelligent Access Program (IAP) in NSW, irrespective of whether operating at GML, CML or HML;
  • PBS vehicles operating at HML are also required to be enrolled and monitored in the IAP in NSW IAP;
  • PBS approved vehicles/combinations at all performance levels (ie Level 1-4) that do not meet the bridge formulae for the level of access being requested (ie Tier 2 and/or Tier 3 bridge compliant) must also be enrolled and monitored in the IAP in NSW irrespective of whether the vehicle is operating at GML, CML and/or HML;
  • As the traffic levels on and east of the Newell Highway are higher compared to the western parts of the State, it is also a road condition that the hauling unit and trailers forming part of a PBS Level 3 vehicles/combinations operating on approved roads on and east of the Newell Highway are nominated vehicles of an operator who holds accreditation for the Maintenance Management module of the National Heavy Vehicle Accreditation Scheme (NHVAS). This is to minimise road safety risks to other road users and the general public by ensuring that the vehicle is always operationally sound. This aligns to the same requirement for prescriptive B-triples, AB-triples and Modern Type 1 A-double road trains;
  • Comply with all the conditions as specified in the PBS Vehicle Approval/ NTC Final Approval;

    Note: Prior to 21 January 2013, PBS approvals were issued by the National Transport Commission (NTC) and approved vehicle/combinations were issued with a NTC Final Approval.
  • Comply with the conditions as specified in the National PBS Notices and/or NHVR issued access permit.

Roads and Maritime Services has published the PBS map to provide the enforceable network for operators of compliant PBS vehicles/combinations seeking to operate in NSW. The map is designed to assist industry in understanding what access is available in NSW for PBS vehicles.

For PBS vehicles eligible to operate on approved routes shown in the PBS map, this will be stated on the NHVR issued access permit and/or in the National PBS Notice.

PBS map

The NSW PBS map shows approved General Mass Limits (GML), Concessional Mass Limits (CML) and Higher Mass Limits (HML) approved network routes in an interactive map format for PBS vehicles approved at:

  • Level 1 and
  • Level 2 access class ‘A’ .

These PBS performance levels have been matched to suitable approved network routes in NSW.

The approved network routes shown in the PBS map are available to PBS vehicles which:

  • Comply with the relevant bridge formulae for the level of access being requested (ie Tier 1 compliant)
  • Have a width of not greater than 2.5m and
  • Have a total height not exceeding 4.3m for Level 1 and 4.6m for Level 2. For more information on 4.6m high access see Using the PBS map.

    Note:
    PBS vehicles that are approved to operate with a height exceeding 4.3m and up to 4.6m must only operate on approved network routes that are approved for both 4.6m high heavy vehicles and the applicable PBS level and access class.

Operators of PBS vehicles must comply with the PBS road network access conditions.

PBS vehicles which do not meet the relevant bridge formulae for the level of access requested (ie Tier 2 and/or Tier 3 compliant) will require individual network assessment.

PBS vehicles which are more than 2.5m wide are currently denied access to Roads and Maritime managed roads until a National review of heavy vehicle width limits is undertaken and the results ratified.

To operate on the approved network routes shown in the PBS maps, you must have:

  • A NHVR PBS Vehicle Approval or NTC Final Approval that approves your vehicle as Tier 1 compliant for the level of performance access you are seeking to operate at
  • An access permit issued by the NHVR authorising your approved level of performance access and Access Class and/or
  • A National PBS Notice that approves access for your PBS vehicle.

Where a route you wish to use is not shown as approved for PBS vehicles, you may request an assessment of the route by contacting the NHVR. Access may be granted under an access permit issued by the NHVR.

The PBS map provides details on the roads and zones approved for the following PBS performance level and access class networks when selecting the corresponding option:

  • PBS Level 1 GML and CML
  • PBS Level 1 HML
  • PBS 2A GML and CML
  • PBS 2A HML.
Click on the button to launch the PBS map
Click on the button to launch the PBS map

Using the PBS map

The PBS map offers pan/zoom, different map views, location search and access to local street images.

Approved routes are shown at each mass scheme ie GML and CML or HML for subject to signposted restrictions for:

  • PBS Level 1 and
  • Level 2 access class ‘A.’

They are enabled or switched off by selecting the PBS performance level and access class using the radio buttons in the legend menu on the left hand side. Information about particular PBS performance level networks eg travel restrictions, is accessed by clicking on the route, which will launch an information box which provides detailed information. Do not cross restricted structures that are displayed where applicable on the maps.

A layer to view approved access for 4.6m high Restricted Access Vehicles (RAV) routes and zones approved for travel is included and is enabled or switched off by clicking the check box in the legend menu. PBS vehicles that are approved to operate with a height exceeding 4.3 metres and up to 4.6 metres must only operate on approved network routes that are approved for both 4.6 metre high heavy vehicles and the applicable PBS level and access class.

By using the zoom and drag features included you are able to view and print maps at the level of detail and covering the area you need. The search function allows you to centre the map on a geographic location based on an address, town, post code, or a set of coordinates.

Disclaimer

The PBS map shows PBS approved network routes, zones and restrictions as an overlay on top of the Google map subject to signposted restrictions. Roads and Maritime Services has no responsibility for and does not guarantee the accuracy of the underlying Google maps.

Roads and Maritime strives to be accurate in showing the PBS approved routes, zones and restrictions, however there may be errors and omissions caused by Google maps being incorrect or out of date. Roads and Maritime is not responsible for errors or omissions due to changes to the map by external organisations.

Requesting access for PBS vehicles in NSW

The NHVR provides a single point of contact when applying to the PBS Scheme. The NHVR will issue all Design and Vehicle approvals as well as advise on and request road network access, where necessary with the relevant road manager.

All PBS applications and enquiries should be submitted to the NHVR.

For enquiries and support:

For enquiries specifically relating to PBS access on NSW state managed roads you can email pbs.queries@rms.nsw.gov.au

    Share this page: